Carl-zeiss Camera Lens Manuel d'utilisateur télécharger pdf (Page 3)

Sharp Max

Carl Zeiss

Camera Lens Division

Bedienungsanleitung Sharp Max 12_02E.doc Status 12 / 2002 Page 3 of 11

1 Product safety

The unit described in this manual has been designed and tested in accordance with Carl

Zeiss safety standards and with national and international regulations. A very high

degree of instrument safety is thus ensured.

We would like to inform you on the safety aspects involved in operating the instrument.

This chapter contains a summary of the most important precautions to be observed.

Further safety notes are also contained in other parts of this manual; they are marked

with frames. Please pay special attention to these safety notes.

Safety is only ensured when this instrument is operated properly. Please read through

this manual carefully before starting up this unit. You may obtain further information from

our service organization.

1.1 CE marking

The version supplied of this unit meets the requirements stipulated in the 89/336/EEC

"Electromagnetic Compatibility" and 73/23/EEC "Low Voltage" Directives.

1.2 Intended use

The unit must only be used for the measurements described in this manual. The

manufacturer will not assume any liability for different measuring procedures.

1.3 Standards

The unit described in this manual is short-circuit-proof and has been designed in

compliance with the following standards:

- IEC / EN 61010 - 1

IEC / EN 60825 - 1

The unit contains light-emitting diodes (LEDs). This is a laser class 1 instrument as

defined by IEC/EN 60825-1:(2001).

The production, inspection, maintenance and repair are performed in compliance with

German and international regulations (Good Manufacturing Practice).

The unit is a protection class 3 instrument.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Carl-zeiss Camera Lens Manuel d'utilisateur Page 3